
Are You a Member of a Club, Public Service Organization, or Military Branch? Call Toll Free 1-(866) 512-5918 to receive your discount coupon code!

Products	Toll Free Order Line: 1-(866) 512-5819 Jeep JK \| Jeep TJ \| Site Map

Audio-Storage

Consoles

Seat Covers

Soft Goods

Soft Tops

Special Deals

Helpful Information

Contact Team Sly

Returns

Shipping

Warranties

Install Instructions: Jeep TJ Sidebars

Product Care
To protect your investment, apply a good quality auto wax after installation and reapply occasionally as needed.

Install Sidebars
Step 1: Remove and discard the two 8mm hex bolts located at the front of the under body support.
Step 2: Loosely mount front of side step to location in step 1, using 8mm bolts, lock washer and flat washer supplied (items 3,4,5). See illustration A. Do not tighten at this time.
Step 3: At rear wheel, remove two fastening clips that retain front of wheel well liner. Pull liner away to expose end of the under body support.
Step 4: Raise rear end of side bar into position at a point where the rear bracket contacts the under body support and center. Mark hole position.
Step 5: Lower side bar and center punch marked holes for drilling.
Step 6: Drill 1/8” pilot holes. Drill 13/32 mounting holes.
Step 7: Fasten rear side bar bracket using two 3/8” hex bolts, flat washers, and lock nuts. Torque 3/8” bolts to 23 ft-lbs.
Step 8: Reposition rear wheel liner, to cover mounting hardware.
Step 9: Tighten front 8mm mounting bolts to 18 ft-lbs.
Repeat steps 1-9 for opposite side.

Illustration A (Front Mounting Position)

Illustration B (Rear Mounting Position)